OPERATION
0
1
270
386
437
260
351
V
A
G
F
•
START-UP
−
Before starting up the machine, it must be checked that all water and electrical supplies are in accordance with the previous
pages.
−
Fill the water tank.
−
Put the switch (F) of the machine on position "1".
The heating now takes place automatically.
When the heating control light is unlit, the machine is ready for use.
•
PREPARING THE COFFEE
ATTENTION : risk of injury through scalding. Never remove the filter-holder before the end of the infusion cycle.
−
Twist the filter-holder to the left and insert one pod in the filter (B).
−
Then twist to the right until held firmly.
−
Place a cup below the delivery spouts (E).
−
Turn the control button (A) to the right to start infusion.
−
Turn the button to its initial position when the quantity obtained in the cup is suitable for you.
Wait for infusion cycle to finish, then twist the filter-holder to the left to place a new pod. The waste pod is automatically
ejected into the box provided, it will hold about 12 pods.
−
After each use it is advised to take the waste coffee off, and to insert the filter-holder in the unit to maintain it on good
temperature.
−
After each infusion, a small quantity of water is ejected into the drip tray (G). You should empty the drip tray each 50 cups
about.
•
PRODUCING HOT WATER (according to model)
−
Place the container below the tube (L)
−
Turn the control button (A) to the left to start the producing of hot water
−
Turn the button to its initial position to stop.
•
PREPARING CAPPUCCINO ( according to model)
−
Immerse the tube (K) in the milk
−
Turn the button (V) to the left to start the impulses. A few seconds can be necessary for the priming of the circuit.
−
Turn the button to its initial position to stop.
After each operation, wipe the steam tube with a damp cloth, then briefly turn the button (V) to the left to get rid of any liquid
left in the tube.
Never leave the steam tube immersed in a liquid, when the machine is not in use.
When the light "tank level" lights, it isn't possible to use the machine any more. So it is necessary to fill the tank to be able to
use again the machine.