1. First, pull the bodies apart and lay the pieces out.
2. Assemble the 2 partially completed Nurseries first, following the 2
pack instructions on the front of this sheet. Use them for reference to
complete the final one, if necessary.
3. To build the final Nursery, first take the longer piece of mesh that is the Nursery body. Square up and connect it together
at the seam, using 5 zip ties spaced apart ensuring seam stability.
4. Next, you’ll attach the bottom. It’s the larger (1.5”) mesh piece. Align the sticker on the body with the sticker on the bottom.
5. You’ll attach the two pieces together with 2 zip ties in each corner. Starting on the seam side, attach the bottom to the
body using 1 zip tie in the first square. Do the same on the other side of the seam. Repeat with the remaining 3 corners.
6. Continue attaching the rest of the bottom by attaching 3 zip ties in between each of the straight edges. You’ll use 20 zip
ties on the bottom. If you wish, clip to remove the long ends of the zip ties and discard.
7. Flip the Nursery over and attach the Limbs to the bottom mesh, inside the enclosure, using 1 zip tie per limb.
8. Next, take the top of the Nursery and position it so you align the sticker on the body with the sticker on the top. Holding it
a couple of inches above the body, reach in and “fluff” the limbs/leaves of the Grass stems to your liking, pulling the leaves
through the holes in the top.
9. When you have the leaves where you want them, lay the top on the body and attach starting with the seam side. On each
corner, count over 2 squares from the seam and attach the top to the body using one zip tie. Do the same on the other
side of the seam. Repeat with the 2nd, 3rd and 4th sides.
10. Continue attaching the rest of the top by attaching 3 zip ties, equally spaced, on each of the sides. You’ll use 20 zip ties in
total on the top. If you wish, clip to remove the long ends of the zip ties and discard.
11. Finish by attaching the marker float to the center of the top using rope - cut to the desired length for the water depth.
12. To install, hold them upright (with the bottom - larger mesh - down) and simply toss them in 2-3’ of water.
2 Pack Assembly
Honey Hole Nursery
Imitating Nature’s Design
WHAT’S INCLUDED IN 3 PACK:
(2) Partially Completed Nurseries
w/ Bottoms, 4 Limbs, & Body
Connected
(3) Tops (1” square mesh)
(1) Bottom (1.5v” square mesh)
(1) Nursery Body
(4) Grass Limbs
(3) Floats w/ String
(89) Zip Ties (20 ea. for 2 partially
completed Nurseries & 49 for 1
needing full assembly)
3 Pack Assembly
We do our best to cut the mesh as close as possible to the ends, but
there are still some slightly sharp edges that could cause scratching
to the hands. Gloves are recommended while assembling the Honey
Hole Nurseries.
Pond King, Inc. | 5924 West Highway 82, Gainesville, Texas 76240 | 940.668.2573 | www.pondking.com
