Polymaker PolyBox, Operation Manual

Page: 11 / 26

11
To install the filament guide
Cut the filament guide according to your
need (Distance from the PolyBox
TM
to the 3D
printer) and insert it in the rubber holes on the
back or on the top.
Caution:
Be careful, at the end of the spool, the filament might get stuck in the PolyBox
TM
and
the 3d printer can drag the PolyBox
TM
.
To place the spool
Place the spool in the PolyBox
TM
and feed the
filament through the rubber plug.
Note: Make sure the material is fully dried
before putting it in the PolyBox
TM
.
Place the cover on the PolyBox
TM
.
You should feel a small friction which ensures
the fit. Make sure the cover fits correctly in
the base to ensure an airtight environment
for the spools. Do not open the PolyBox
TM
too
frequently and close all the unused rubber
plugs to preserve the desiccant.
Gently pull the filament out to check if the
spool rolls smoothly.
After 2 hours you should see the inside
humidity dropping below 15%. The time will
depend on the room humidity. The hygrometer
should always display a humidity level below
15%.
Note : The minimum humidity level that can
be displayed is 10%
If the hygrometer displays a humidity level
above 20%, replace the desiccant.
4
5