SAN2-1001/SAN2-1002 Assembly - May 2020
Page 3 of 4
Assembly Instructions Cont.
Step 12:
Insert the tab on the top panel into one of the
slots at the top of one of the sides. Using a screwdriver
or other tool to pry with, pry the opposite side out so that
the tab will insert into the corresponding slot.
Assembly is complete
Dispenser Installation
(See included instruction sheet if installing the FD1-1000 Foam Dispenser)
Step 6:
Remove the lid by turning counterclockwise and lift up.
Step 7:
Push the locking tab back and lift up on the dispenser container.
Step 8:
Holding the backing plate in the place where you would like to mount the dispenser,
mark the placement for the three mounting holes. Use a drill with a 3/16” drill bit to drill the
holes in the marked spots.
Step 9:
Secure the backing plate in place using the desired fasteners. If riveting, please rivet
from the outside using the PC-000104 rivets with PC-000106 washers on the inside. If using the
PC-000229 screws, insert the screw through the backing plate and apply a PC-000106 washer
and PC-000230 nut on the inside. Tighten in place using a phillips screwdriver with 3/8” wrench.
Step 10:
Slide the liquid container back in place, making sure the locking tab is in place,
and fill with desired soap or hand sanitizing solution. If the dispenser is fitted with a foaming
pump, only foaming soap/hand sanitizing solution may be used.
Step 11:
Replace the lid and secure in place by turning clockwise.
1) Push In Tab
2) Lift Up Container
Maintenance and Care
• Use only mild cleaners with no abrasives using a soft cloth to clean all surfaces.
• Some silicone grease should be applied occasionally to the o-ring at the top of the soap
container to keep the lid from sticking. Mineral oil should NEVER be used.
• If there is a chance for freezing, remove the dispenser and drain the soap. Be sure to
remove the soap from the pump as well.
• All testing and statements thereof pertain to PolyJohn approved chemicals. Any results
of non-approved chemicals to PolyJohn products are the responsibility of the customer.
OUR MISSION STATEMENT
“PolyJohn is a family owned, state of the art, plastics manufacturing company dedicated to providing its employees with a work
environment committed to excellence, and its customers with innovative products, services and technology that meet or exceed
their requirements.”
THANK YOU FOR PURCHASING POLYJOHN PRODUCTS!
For a video demonstration of assembly and more product information, visit
www.polyjohn.com/emergency-sanistand
For more products and information, visit
www.PolyJohn.com
2500 Gaspar Ave., Whiting, IN 46394
