48” & 52” Ladder Shown
FIG. 3
FIG. 4
2
6
7
8
9
3
3
36” & 42” Ladder Shown
2
9
8
6
4. Repeat Steps 2 and 3, installing the rest of the Ladder Step Clips
5
and Ladder Step
3
for the first section.
5. Assemble the second ladder leg section in the same manner, repeating step 2- 4.
6. The Machine Screws
6
in
FIG 3
should be installed from the inside of the Ladder Handle
2
, and out through the Ladder Handle Brace
10
on
the outside. Make sure that the English warning is facing out on both handle sections. Install the Lock Washer
8
, and thread the Cap Nut
9
on
until the Ladder Brace tightens up against the Handle.
Install Ladder Handles
2
so that the braces with the warning
are on the outside of the ladder legs, as shown.
*
*
7. Stand both ladder leg sections in the upright position, with feet facing outward, as shown in
FIG 4
. Place the Ladder Handles
2
, with the ladder
handle braces on the outside of the ladder, on top of both ladder leg sections.
8. Make sure all of the steps are now level (parallel to the ground). If one section is different, lift handles and turn the ladder leg section around.
Re-install handles and push down tightly.
9. From the inside of the ladder handles, insert the four Machine Screws
6
through the flat Washers
7
, then through the handle and fasten in
place using the four Lock Washers
8
and Cap Nuts
9
. See
FIG 3
.
NOTE: THIS STEP IS VERY IMPORTANT BECAUSE IT KEEPS THE HANDLES FROM SEPARATING FROM THE LEGS. LADDER FAILURE WILL RESULT IF
SCREWS ARE NOT PROPERLY INSTALLED! See
FIG 3
.
OWNER′S MANUAL
8
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
