background image

 

 

Polycom

®

 KIRK IP Interface Card - User Guide 

 

1. Introduction 

This  guide  helps  you  setting  up  the  KIRK  Wireless  Server  1500  with  IP  Interface  Card  on  a  Cisco  CallManager. 
Please refer to your CallManager user manual for general information. 

 

 

2. Installation 

1.

 

Power down the WMS (Wireless Mobility Server). 

2.

 

Remove the top cover by unscrewing the screws on both sides of the WMS and the screws at the rear panel. 

3.

 

Remove the blind cover plate in front of the slot 
closest to the power supply (please refer to the 
figure at right). 

4.

 

Insert the KIRK IP Interface Card into the slot 0 
(see drawing) and mount the two screws from the 
blind cover. 

5.

 

Put back the top cover. 

6.

 

Connect an RJ45 cable (not included) between the 
KIRK IP Interface Card on the back of the WMS 
and the LAN network. 

7.

 

Power up the WMS again. 

8.

 

Verify that the LED’s are flashing as follows: 

 

Active 

In HTTP mode and when packets are transmitted on the Ethernet the Active LED is turned on.  

100 

In HTTP mode and when the Ethernet speed is 100mbps the 100 LED is turned on. When 10mbps Ethernet is 
connected it will be off. ‘ 

Link 

When the Ethernet link layer is established the Link LED is turned on. 

Ready 

When the system is running and ready the Ready LED is turned on. If the system is not ready the LED will start 
flashing. In TFTP mode the Ready LED is flashing and all other LED’s are off. 

Front LED

 

The front LED is green when the system is running and the subscriptions are read

 

 

Software and help files are available at: http://www.kirktelecom.com/Installers/suk227.asp 

 

 

 
 

 

Reviews: