Check the Screens and Run the Wizard
11
Check the Screens and Run the Wizard
Make sure the Welcome screen image is centered properly on the screen.
If you need to adjust the projected image, follow
the instructions in the “Adjusting the Projected
Image” section of the
Rear Projection SMART
Board 3000i Installation Guide
.
The adjustments that you make at this point are
coarse adjustments; you will be able to make fine
adjustments later.
Make sure the Welcome screen image is in focus.
If you need to adjust the projector focus, follow
the instructions in the “The NEC VT670
Projector” section of the
Rear Projection SMART
Board 3000i Installation Guide
.
Complete the VSX setup wizard.
•
Use the Polycom remote control to complete
the wizard. For information about using the
remote control, refer to the Polycom
Getting
Started Guide for VSX Series Systems
.
•
Touch control is not enabled at this stage of
the setup; however, you will be able to use
touch control for most of the system
configuration and customization.
•
For information about the VSX system, refer
to the Polycom
Administrator’s Guide for the
VSX Series
.
1
2
3
