Call Routing
49
Edit the Outbound Call Route Configuration
You can edit the outbound call route configuration to limit the numbers each handset can dial.
To edit the outbound call route configuration:
1
Go to
DECT Wireless > Handsetn
.
2
In the
Default
column, clear the check box for the parameters you want to edit.
3
In the
Value
columns for these parameters, enter your changes.
Poly recommends keeping the default parameters. For more information on editing outbound call
route configuration, see the
VVX D230 DECT IP Phone Technical Reference Guide
on the
Multiline Setup
After you configure the primary line on the VVX D230 DECT IP Phone, you can configure additional Service
Provider and OBiTALK lines on registered handsets.
You can assign handsets with the following types of lines:
●
Inbound service provider lines
●
Outbound service provider lines
●
OBiTALK (peer-to-peer) lines
You can assign two or more inbound or outbound lines and an OBiTALK line to up to ten handsets, assign
a primary line for each handset, and label each handset.
Assign Inbound Call Lines
You can assign each handset with up to eight designated service provider lines for receiving incoming calls
and assign which handsets can receive calls from OBiTALK (peer-to-peer) lines.
To assign inbound call lines:
1
In the system web interface, go to
DECT Wireless > Multiline Setup
.
2
Select the check boxes for the handsets that will receive incoming calls for each service provider line
and from OBiTALK devices.
Assign Outbound Call Lines
You can assign each handset with up to eight designated service provider lines for placing outgoing calls
and assign which handsets can place calls to OBiTALK (peer-to-peer) lines.
To assign outbound call lines:
1
In the system web interface, go to
DECT Wireless > Multiline Setup
.