ME-51 Subwoofer Amplifier
4
————————————————————————————
PO Box 409 Hanover, MD 21076
www.polyplanar.com
(410) 761-4000
poly-planar
Waterproof Marine Audio
Connecting the ME-51 Power and Speakers:
8) The Black and Red power wires should be connected directly to the
vehicle battery or main fuse block using heavy gauge wire (AWG #16 or
lower). Black = GROUND, Red = +
9) The Blue REMOTE wire turns on the amplifier. Connect this to the
remote wire of your receiver, or connect to an on/off toggle switch or
Accessory circuit.
10) Connect the white and grey loudspeaker wires to Subwoofer side screw
terminals. Pay close attention to polarity. Connect black striped wire
(negative) to the Black ringed terminal. If one of the connections is
reversed then the subwoofer will produce no output.
11) When mounting the amplifier on a remote surface, use the included
connector pigtail harness. When mounting directly on the Subwoofer,
the wire ends can be cut, stripped, and connected directly to the gold
screw contacts on the subwoofer.
SPEAKER
OUTPUT
POWER
poly-planar
EXPANSION AMPLIFIER
ME-51
(Blue) remote on
(Black) Ground
(Red) B12V
Speakers
White
White / stripe
Grey
Grey / stripe
RIGHT
LEFT
Figure 3 - Speaker & Power connections
12V Battery
ACC Switch or
Radio Remote
Line
