poly-planar GSMR20, Owner'S Manual

Page: 5 / 15

5
1.Choose a mounting location on the dash board or instrument panel that
will allow room behind to run radio cables to the power source. Consider
how you will use the AUX IN, LINE OUT and USB connectors and route the
appropriate extension cables to an accessible area.
2.Cut a hole Diameter: 80mm/3.15 inch in the dash board using the
provided template. At least 3.5-inch depth is needed to mount the radio.
IMPORTANT! Do not mount this unit where it can be submerged in
water.
3.Attach the included screw posts (A) to the back of the radio.
4.Place the radio in front of the dashboard opening so the wiring can be
brought through the opening.
5.After completing the wiring connections (refer page
3 ), turn on the radio to
confirm operation (vehicle accessory switch must be on). If the radio does
not operate, recheck all wiring until the problem is corrected. Once proper
operation is achieved, turn the accessory switch off and proceed with final
mounting of the radio. Refer to the wiring diagram on page
3 .
NOTE: Before final installation, test the wiring connections to make
sure the unit is properly connected, and the system works.
6.Insert the radio into the mounting hole.
7.Place the 'U' bracket (B) over the screw posts and secure the radio to the
dash using the included hex nuts (C).