LECOASPIRA INTELLIGENT 2.0
179
ENGLISH
AFTER USE
1) OPERATIONS TO BE CARRIED OUT AFTER USE
Switch off the appliance by pressing the main switch
(1)
(Fig. 7) and disconnect the plug from the
electricity socket.
Disconnect the monoblock plug
(A6)
from the appliance by pressing the button
(A7)
and by pulling
the plug to remove it from the appliance.
2) EMPTYING AND CLEANING THE DIRT CONTAINER
After having turned the appliance off and disconnecting it from the electricity, empty the water con-
tainer (
20
) One of the great advantages of Vaporetto Lecoaspira is in fact the possibility of clea-
ning it, thereby avoiding all risk of the spread of micro-organisms.
Lift the water container (
20
) removing it with the container handle (
22
)(Fig. 3).
Turn the handle as per (fig. 4) eand remove the “ Eco-Active” water filter assembly (
23
).
Empty the container by tilting it towards the spout (Fig.10).
Pull the elbow tube (
27
) from the filter body with the micro pore net (
26
) until it slides off (Fig. 11a).
Separate all the components and rinse them under running water. (If the filter sponge has tears,
replace it. To purchase one, contact an authorized Polti Service centre).
After drying the various components of the “Eco-Active ” water filter, reinsert the water filter assem-
bly, in the water container (
20
).
ATTENTION: align the arrow located on the elbow pipe (
27
) with the reference notch located on
the filter body (
26
) (Fig. 11b - 11c).
Replace the water container (
20
) as described in the chapter “preparing for use”.
A recommendation for cleaning the container and the extension tubes, if particularly dirty:
once cleaning is complete, empty the container as described and place it back in its housing on the
body of the appliance. Connect the appliance to the mains.
Then vacuum up approximately 1.5 litres of clean water using the suction function for a few
seconds.
The water vortex created inside the container will rinse the sides and remove any dirt. The clean
water will also clean the inside of the tubes as it travels through them.
Empty the container again and put Vaporetto Lecoaspira away.
3) CABLE STORAGE
Before putting Vaporetto Lecoaspira away, store the power cable (
13
) in the specific space (
15
)
proceeding as described below::
• Remove the water container (
20
) as described in the chapter “preparing for use”.
• manually wind the cable evenly and replace it in the specific space (
15
), making it go into the
cable storage (
14
) (Fig. 8);
• replace the water container (
20
) in its storage making sure to position it correctly..
LECOASPIRA INTELLIGENT vers. 2012_mod7:Layout 1
11/04/2012
8.49
Pagina 179
