VAPORELLA FOREVER 1400- 1402 - FOREVER 1405 PRO
16
ENGLISH
STEAM IRONING
• Adjust the temperature of the iron to the
"COTTON - LINEN" position by turning the
dial (
7
) (fig. 3).
• Adjust steam pressure according to the
type of fabric to be ironed by turning the
steam flow control knob
(6)
to one of the
following 3 options (fig. 4):
• The Steam pressure indicator
(B)
flashes.
• Before starting to iron, wait for the steam
pressure indicator
(B)
to remain on fixed
and the “Iron heating” indicator light
(11)
to
go out.
• Push the button (
10
) on the iron to release
bursts of steam from the holes on the sole-
plate. Release the button and the steam
flow stops.
NOTE:
during initial operation of the iron, a
few drops of water mixed with steam may
come out of the soleplate until the tempera-
ture stabilises. It is advisable to direct the
first jets of steam onto an old cloth until a
uniform jet of steam is obtained.
• In order to have a continuous steam jet,
move the button (
10a
) forwards. Steam will
keep on coming out, even releasing the
steam request button. To interrupt the ou-
tlet, move the button (
10a
) backwards
(fig.5).
DRY IRONING :
• To dry iron, regulate the iron temperature
using the slider
(7)
to the temperature re-
quired by the fabric.
• Position the steam flow control knob
(6)
to
“DRY”. On this setting, the boiler remains
off and steam cannot be generated. Only
the iron will remain operative.
NOTE:
• The “Iron heating” indicator light
(11)
turns
on and off during use. This indicates that
the electrical resistor has started to work to
keep the temperature in the iron steady.
This is a normal occurrence, and it is the-
refore possible to continue ironing.
SHORTAGE OF WATER
The lack of water in the tank
(3)
is signalled
by the indicator light
(C)
coming on.
To return to ironing, proceed as follows:
• Fill the tank
(3)
again, as described in the
paragraph “PREPARATION”.
• Press the “RESET” button
(5)
to cancel the
shortage of water alarm. The indicator light
(C)
will go out.
PUTTING AWAY THE
APPLIANCE
Make sure the appliance has cooled down
completely before putting it away.
• Tug on the power cable gently (
9
) until it
clicks once, and then accompany it with
your hand as it is automatically wound up
by the cable winder (
9a
).
• Position the monotube
(8)
in the specific
housing
(8a)
(fig. 6).
• Carry the Vaporella by its convenient carry
handle (
1
) (fig.6).
ATTENTION:
before moving Vaporella with
the handle, make sure that the power supply
cable (
9
) and monotube (
8
) have been stored
as described previously.
ENERGY SAVING
STAND-BY FUNCTION
After 10 minutes of the appliance not being
used, it automatically goes into stand-by
mode. Both the boiler and iron are switched
off.The indicator lights
(A), (B) and (C)
flash
simultaneously.
To re-activate the appliance, press the steam
request button
(10)
f or at least 1 second.
N.B.: The stand-by function will not be applied
if the steam flow control knob
(6)
is set to
"DRY".
Intensità di vapore leggera
for synthetic or delicate fabrics
Medium steam
for wool and fibres
Strong steam
for cotton, denim and linen
VL FOREVER 1400-1402-1405 - M0S10930 -
1U02:FEV 1000-950.qxd
25/02/2014
16.45
Pagina 16