POLTI SANI SYSTEM, Instruction Manual, Page: 43 / 128

slides off the filter unit (36).
22.6 Separate all the components and rinse
them under running water (37).
22.7 Dry the various components of the filter,
reassemble it and reinsert it into the dirt
collector.
22.8 Reposition the water filter collector in
the appliance.
23. CLEANING THE HEPA FILTER
(extraordinary maintenance)
23.1 Ensure that the appliance is switched off
and disconnected from the mains.
23.2 Lift the water filter collector removing it
from its housing using the container handle
(2).
23.3 Lift the release lever of the HEPA filter
and remove it from its housing (39).
23.4 Rinse the HEPA filter using running
water only and shake gently to remove any
excess dirt or water residue; before replacing
the filter in the appliance, leave to dry
naturally away from sources of heat for at
least 24 hours.
The HEPA filter should be fully cleaned
approximately three times per year.
24. SPARE SEALS
Periodically check the status of the coloured
washer located in the built-in socket. If
necessary, replace with the corresponding
spare part, as described below.
Perform the same check on the connection
seals of the extension tubes and the handle of
the hose. If necessary, operate as follows.
25. STORAGE
25.1 Turn off the appliance and disconnect
from the mains electricity.
25.2 Remove the water filter collector as
indicated in Section 1.
25.3 Manually wind the cable evenly and
replace it into the holder, passing it into the
power cable storage space (40).
25.4 Replace the water filter collector in its
housing, making sure to position it correctly.
25.5 The hoses, brush and flexible hose can
be housed on the body of the appliance,
sliding the hook on the universal brush into
the parking system on the appliance (40).
To clean the water filter collector and the
extension tubes, if they are especially dirty,
once the cleaning operations have been
completed, empty the container as descri-
bed and replace it in its housing in the ma-
chine. Connect the appliance to the mains.
Then vacuum up approximately 1.5 litres of
clean water using the suction function for a
few seconds. The water vortex created insi-
de the collector will rinse the sides and re-
move any dirt. The clean water will also
clean the inside of the tubes as it travels th-
rough them. Empty the collector again and
put Vaporetto Lecoaspira away.
WARNING: Check the filters during cleaning.
Replace the filters when visibly damaged.
WARNING: Do not clean the filter with the
brush as it can be damaged, thereby redu-
cing its filtering capacity. Do not use deter-
gents, do not rub the filter, and do not wash
it in a dishwasher.
- Remove the damaged washer.
- Insert the new washer, attaching it
on the steam nozzle and pushing it
into place.
- Lubricate the gasket with silicone
grease or Vaseline, or alternatively
with small quantities of vegetable
oils.
- Remove the damaged washer.
- Insert the new washer, applying it on
the steam nozzle and pushing it into
place.
- Lubricate the gasket with silicone
grease or Vaseline, or alternatively
with small quantities of vegetable oil.
The hook is present only on extension tubes.
Incorrect assembly of the two extension tu-
bes will prevent the use of the appliance
parking system.
WARNING: Check the filters during cleaning.
Replace the filters when visibly damaged.
E
N
G
L
IS
H
| 43 |
All manuals and user guides at all-guides.com