POLTI lecoaspira vaporetto FAV50 multifloor, Instruction Manual, Page: 44 / 120

Should the problems persist, contact an Authorised Polti Service Centre (see www.polti.com
for the up-to-date list) or Customer Services.
PROBLEM CAUSE SOLUTION
Accessories are difficult to
assemble.
The seals produce friction.
The locknut is not in the
correct position.
Lubricate the seals with silicone
grease or Vaseline, or alternati-
vely with a small amount of ve-
getable oil.
Turn the locknut to the correct
position as indicated in Section
2.
After vacuuming liquids, the
liquid vacuumed comes out
of the brush.
Liquid remains inside the
tubes.
Floor is still not dry.
Suck in air for a few seconds to
allow the transfer of the liquid to
the tank.
Repeat the vacuuming opera-
tion.
The appliance turns off while
using suction.
Water filter collector full
or motor overheated.
Turn off anddisconnect the ap-
pliance from the mains. Empty
the dirt collector and clean it. If
the problem persists, turn off
and disconnect the appliance
from the mains and wait 60 mi-
nutes for it to cool.
When pressing the boiler
button, it does not turn off.
The Multifloor feature has
been activated.
Press the boiler button again, un-
til it turns off.
IT
A
L
IA
N
O
E
N
G
L
IS
H
| 44 |