FORZASPIRA C110
17
ENGLI
SH
♦ Remove the handle (
6
) by turning it anti-
clockwise compared to the container (
7c
),
aligning the two reference arrows (Fig. 9b).
♦ Remove the container filter (
7a
) and pull out
the filter unit (
7b
) and remove any remai-
ning dirt.
N.B.:
We recommend to clean the contai-
ner after each use.
ATTENTION:
never exceed the “MAX” level
shown on the dust container (
7
), otherwise
the filters will clog reducing the suction
power of the appliance.
♦ Replace the filter unit (
7b
) in the container
(
7c
), making sure that the two arrows are
aligned (Fig. 10).
♦ Replace the air filter (
7a
).
♦ Reassemble the handle (
6
) on the container
(
7c
) turning it clockwise, making sure to ali-
gn the two arrows (Fig. 9a).
♦ Reposition the dust container on the ap-
pliance by repeating the steps described
previously in the opposite order (Fig. 7).
ATTENTION:
do not use the appliance
without the dust container (
7
) complete with
filter.
USING ACCESSORIES
Accessories may be connected directly to the
hose (
A
) or to the telescopic tube (
B
).
Using the telescopic tube (B)
The length of the telescopic tube can be adju-
sted. Just press the button (
B1
) to extend it or
shorten it at will.
Use of the accessories holder (C)
The accessories holder allows the accessories
to be fastened (
E
) and (
F
) to the telescopic
tube (
B
), so they are always close at hand.
Just hook the single ring (
C1
) to the telescopic
tube and insert the accessories (
E
) and (
F
) in
the 2 other rings (Fig. 11).
Parquet brush (D)
The parquet brush is designed to clean deli-
cate surfaces; it has bristles and wheels in a
special material
to avoid damaging the surfaces.
Small nozzle (F)
The small nozzle is recommended for clea-
ning upholstery surfaces such as the joints of
sofas, armchairs, mattresses, car upholstery,
etc.
Lance for corners cleaning (E)
This lance is suitable for thorough cleaning of
the more difficult-to-reach places, like skirting-
boards, sofa gaps, armchairs, upholstered
furniture, car seats.
Using the universal brush (G)
Connect the brush to the telescopic tube (
B
).
If you move the selector on the brush (
G2
)
and press with a foot, you can change the
suctioning surface without bending down. The
position with bristles extended is recommen-
ded for all non-carpeted floors. The position
without bristles is recommended for carpets.
AUTOMATIC CABLE WINDER
Before starting the automatic cable rewind, by
pressing the button (
4
), make sure that the
power plug is disconnected from the mains
electricity. We recommend following the cable
during the operation.
PUTTING THE APPLIANCE AWAY
It is possible to replace the appliance by re-
sting the
brush (
G
) with the tube (
B
) in the parking hou-
sing (
2
) as shown in Figure 8.
CARE OF YOUR APPLIANCE
•
Before attempting any maintenance
operation, always disconnect the ap-
pliance from the mains.
• To clean the body of the appliance, simply
use a moist cloth. Do not use solvents or
detergents which may harm the body mate-
rial.