ENGLISH
Espresso 2000
P
P
P
P
R
R
R
R
E
E
E
E
P
P
P
P
A
A
A
A
R
R
R
R
A
A
A
A
T
T
T
T
II
II
O
O
O
O
N
N
N
N
O
O
O
O
F
F
F
F
C
C
C
C
A
A
A
A
P
P
P
P
P
P
P
P
U
U
U
U
C
C
C
C
C
C
C
C
II
II
N
N
N
N
O
O
O
O
1c) Switch on ESPRESSO 2000 as indicated in the
“preparation for use” section. When the coffee dispenser
button (4) lights up, press the steam preparation button
(5), the button will glow red.
2c) Wait for the light (
4
) to go out (about 30 seconds).
3c) Move the steam dispenser (
7
) to above the drip-tray.
Open briefly the steam dispenser handle (
6
) to eliminate
any remaining condensation from the tube (fig. 7).
4c) Move the steam dispenser to a position outside the machine, so that you can immerse
it in milk to a depth of about 3 cm taking care not to hold it directly to the bottom of
the container which would impede the escape of steam.
Note:
For the best frothing, we recommend you use very cold, skimmed milk.
5c) At the end of the frothing close the handle again (
6
) and remove the dispenser from
the milk.
Important!
Only remove the dispenser from the milk after you have closed the handle!
6c) Switch off the steam preparation button.
7c) Push the steam dispenser (
7
) back to its original position above the drip-tray.
8c) Press the coffee dispense button (
4
) until some water begins to escape from the
dispenser, so as to arrive again at the correct quantity of water in the generator.
C
C
C
C
A
A
A
A
R
R
R
R
E
E
E
E
!!
!!
Before switching on the machine, make sure there is water in the container (
10
). Lack of
water is also signified by the indicator light (
3
) showing a red light.
The audible signal and indicator light are pre-set to come in to operation at the point where
there is minimal water in the tank. This is to ensure that ESPRESSO 2000 is never
completely empty of water.
Fig. 7
Summary of Contents for ESPRESSO 2000
Page 1: ......
