A R O M A
R A F F A E L L O
67
facturer; use only special Polti lime scale remover.
When the machine requires lime scale removal, the
symbol will appear on the display and the
service button (
7
) will start flashing.
RECOMMENDATION:
Press the service button
before starting the lime scale removal procedure.
You may continue making coffee, hot water and
steam, but we recommend you run the lime scale
removal procedure promptly.
Important: - Do not interrupt the lime scale re-
moval programme once it has started!
1m.
Press the service button (
7
) for about 2
seconds. The
symbol will start flashing.
2m.
Empty the drip tray (
9b
) and reassemble it.
The
symbol will flash, while the
sym-
bol will come on.
3m.
Remove the water reservoir (
17
) and put two
Polti lime scale remover tablets in it (following
the manufacturer’s instructions) with the cor-
responding quantity of water, up to the 0.5 li-
tre mark.
Important: do not put lime scale removal
tablets into the ground coffee compart-
ment (20).
4m.
Put the reservoir back into the appliance. The
symbol will start flashing.
5m.
Place a recipient of sufficient size (about 1/2
litre.) under the hot water/steam nozzle (
12
)
6m.
Turn the steam/hot water knob (
11
) to the ri-
ght to open.
7m.
The machine will automatically remove lime
scale, and the lime scale removal solution will
intermittently flow out of the hot water nozzle
(
12
) (about 10 min.). The
symbol flashes
during this procedure.
8m.
When the
symbol starts flashing again,
turn the knob (
11
) again.
9m.
At this point the lime scale removal solution
flows into the drip tray (about 15 Min.).
10m. As soon as the lime scale removal solution
has flowed out, the
symbols will
start flashing.
11m. Remove the drip tray (
9b
) and the water re-
servoir (
17
) and empty them.
12m. Fill the water reservoir (
17
) with cold water
and reassemble the water reservoir and drip
tray on the appliance. The
symbol will
flash.
13m. Turn the steam/hot water knob (
11
) to the ri-
ght to open.
14m. The system is once again washed intermitten-
tly through the steam – hot water nozzle (
12
)
(about 5 minutes).
15m. When the
symbol starts flashing, you
can turn the knob (
11
) again.
16m. The system is washed and water flows into
the drip tray (about 5 minutes).
17m. When the washing cycle has been completed,
the
symbol will start flashing.
18m. Empty the drip tray (
9b
) and reassemble it on
the machine.
19m. The system quickly heats up to the correct
temperature. The service button (
7
) will flash.
20m. Press the service button (
7
) to wash the sy-
stem out through the coffee outlet (
8
).
21m. The machine is now ready for use.
Manual lime scale removal
If necessary, the lime scale removal programme
may be started up before the alarm appears.
1n.
Turn the machine on with the On/Off button
(
2
) (operative mode).
2n.
Press the service button (
7
) for about 2
seconds. The
symbols will come on in
sequence.
3n.
Wait until the
symbol comes on and con-
firm by briefly pressing the service button (
7
).
The
symbol begins flashing.
4n.
Press the service button (
7
) again for about 2
seconds. The
symbol will start flashing.
5n.
Proceed as described in point 2m of the "Li-
me scale removal programme" section.
If you unintentionally start up the lime scale removal
programme, you can interrupt the procedure at the
start of the cycle by pressing the On/Off button (
2
)
for about 2 seconds.
GENERAL CLEANING
Never submerge the appliance in water.
Do not use abrasive cleaners.
•
Clean the case inside and out using only a soft,
damp cloth.
•
Empty the drip tray (
9b
) and the coffee grounds
container (
9c
) only when instructed to do so on
the display. Clean with warm, soapy water occa-
sionally.
•
When cleaning the drip tray (
9b
), always remem-
ber to clean the contacts (
9d
) on the back of
the tray.
EE
EE
NN
NN
GG
GG
LL
LL
II
II
SS
SS
HH
HH
Summary of Contents for Aroma Rafaello
Page 1: ......
Page 2: ......
Page 16: ...71 E E E E N N N N G G G G L L L L I I I I S S S S H H H H N O T E ...
