HOOK-UP OPTIONS
OPTION #3
(FIGURE 7)
This method is for use with electronics
featuring a “PRE OUT.” Connect the left
and right preamp output from your elec-
tronics to the left and right LINE LEVEL
input of the subwoofer. This may require
use of RCA “Y” cables (not supplied) to
hookup both the subwoofer and your
electronics. When using option #3, it is
necessary to adjust the settings on your
electronics as follows: Front speakers =
“LARGE,” Subwoofer = “OFF” or “NO.”
HOOK-UP OPTIONS
OPTION #2
(FIGURE 6)
This method can be used with electron-
ics that include a “SUB OUT” feature.
Connect a single RCA cable from the
“SUB OUT” of your electronics to the
LFE input of the subwoofer. This input
bypasses the subwoofer’s variable low
pass filter and relies on the filter built
into your electronics. If your “SUB
OUT” is an unfiltered signal (check
your owner’s manual), use either left
or right “Line Level Input,” to use the
low pass crossover in the subwoofer.
When using option #2, it is necessary
to adjust the settings of your electron-
ics as follows: Front speakers =
“LARGE” or “SMALL” depending
on their output capabilities;
Subwoofer = “ON” or “YES.”
8
9
Polk Audio Customer Service:
800-377-7655 (Outside US: 410-358-3600) [email protected]
For Accessories & Info, Visit:
www.polkaudio.com
This method is for
use with electonic
components featuring
a PRE OUT.
FIGURE 7
OPTION #3
PRE OUT
HOOKUP
OPTION #2
SUB OUT
HOOKUP
This method is for
use with electronics
that include a
“SUB OUT” feature.
FIGURE 6
