Polestar 2 2020, Manual

Page: 406 / 568

Fitting and removing
the towing eye
Use the towing eye when towing. The towing
eye is screwed into a threaded socket behind a
cover on the right-hand side of the bumper,
front or rear.
Fitting the towing eye
1. Take out the towing eye, which can be found
in the foam block in the front cargo area.
Front: Remove the cover – push on the
cover.
> The cover pivots around its centre line
and can then be removed.
Rear: Remove the cover – use a coin, key or
similar to prise out the cover.
> Fold out the cover entirely and take it off.
Screw in the towing eye until it reaches its end
stop.
Screw the eye in firmly. For example, thread
through the wheel bolt wrench and use it as a
lever.
Removing the towing eye
– Unscrew and remove the towing eye after
use and return it to the foam block.
Finish by refitting the cover onto the bumper.
Related information
• Towing (p. 405)
• Activating and deactivating towing mode
(p. 407)
• Opening and closing the bonnet (p. 501)
• Recovery (p. 407)
• Tool kit (p. 467)
IMPORTANT
It is important that the towing eye is firmly
screwed into place - right in until it stops.
406 Starting and driving