Polestar 2 2020, Manual

Page: 344 / 568

IMPORTANT
Driver support components must only be
maintained at a workshop – contact Pole-
star Support.
NOTE
Dirt, ice and snow covering the sensors
may cause incorrect warning signals,
reduced or no function.
Symbols and
messages for camera
unit
Here are examples of some of the messages
and symbols relating to the camera unit that
may be shown in the driver display.
Sensor blocked
If the driver display shows this
symbol and the message
Windscreen sensor blocked
See Manual , this means that
the camera unit cannot detect
other vehicles, cyclists, pedes-
trians and large animals in
front of the car, and that the car's camera-based
functions may be disrupted.
The following table presents examples of possi-
ble causes for a message being shown, along
with the appropriate action:
Cause Action
The windscreen surface in front of the
camera unit is dirty or covered with ice or
snow.
Clean dirt, ice and snow from the windscreen sur-
face in front of the camera unit.
Thick fog and heavy rain or snow block
the camera view.
No action. Sometimes the unit does not work during
heavy rain or snowfall.
Water or snow from the road surface
swirls up and blocks the camera view.
No action. Sometimes the unit does not work on a
very wet or snow-covered road surface.
Dirt has entered between the inside of the
windscreen and the camera unit.
Cleaning the windscreen inside the unit cover is
necessary – contact Polestar Support.
Strong oncoming light No action. The camera unit is reset automatically in
more favourable light conditions.
Defective camera
If a camera sector is black and
contains this symbol then it
means that the camera is out
of order.
344 Driver support