P. 8
User
Guide
Valet Modes
Valet Mode Using the Valet Switch
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o Valet Mode:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec., press the valet button. The parking lights will flash 3 times.
3.
Turn the ignition key to the
IGNITION OFF
position.
The L.E.D. will come
ON
solid indicating that the vehicle is now in valet mode.
To take the system o u t o f Valet Mode:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec., press and release the valet button.
The parking lights will flash twice and the L.E.D. will come
OUT
,
indicating that the vehicle is
now out of valet mode.
Note
: Once Valet Mode is activated, the remote starter will be disabled.
“Home Valet
TM
” Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note:
Once the Home Valet Mode is activated, the vehicle will not start by remote
.
To take the system i n t o Home Valet Mode:
•
Press the
LOCK
or
UNLOCK
button.
•
Within 3 seconds, press the
AUX
button until the Parking Lights go
out
To take the system o u t o f Home Valet Mode:
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
•
Go
ON
then
OFF
; then
•
Flash
twice
, pause; then
•
Flash
twice
again.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
Proceed as follows to set the system to Turbo Mode:
1.
With the engine already running, press the
LOCK
button on the transmitter until the
parking lights come
ON
.
2.
Remove the ignition key from the ignition switch.
The engine will go on running.
3.
Exit the vehicle and close the door.
Press
the
TRUNK
button to lock the doors; the engine will shut down after
60 seconds of Turbo Mode.
Engine Run Time
If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3, 15,
or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
