-5-
Legend
1.Power LED 2.Up Button 3.Menu Button 4.Down Button
1 2 3 4
-6-
CARE AND MAINTENANCE
SPECIFICATIONS
CLEANING
Do not clean or wipe the Back-Up Camera with solvents or chemical materials. If necessary,
remove dirt or stains using a soft cloth dampened with a mild detergent solution.
DISPOSAL
The Back-U Camera is designed to provide years of service. The Back-Up Camera should be
recycled or safely disposed of at a local recycling center. Examples of places that will accept
items like this are: county or municipal recycling drop-off centers or scrap metal dealers.
Camera
Current consumption (with transmitter) <250 mA
Pixels
View angle (measured 9.8 ft [3 m]from camera) 120
士
15
Power cord fuse DC12-24V 1A
Transmitter
Frequency 2414
土
0.3 MHz
RF transmission distance 495 ft (150 m)
Operation/storage temperature 14-140F(-10-60C)
Monitor
Display screen size 4.3 in. (109 mm)
Power cord fuse DC 5V 1A
640 x 480
NOTICE
In extremely bright conditions, the screen image may take a few seconds to stabilize. Wait until
the image has stabilized before backing up.
1.Press the menu button to bring up the settings screen.
2.Press the menu button to scroll through the different adjustments. Press the up button to
increase or the down button to decrease settings.
3.The monitor can be mounted in any position. To change the view on the screen, scroll to
direction. Press the up or down button to change the view and display the image correctly.
4.To exit, scroll to exit and press the down or up button.
5.To turn the guidelines on or off, press the guidelines button.
OPERATION
Testing the System
1.The blue LED will light when power is on.
2.With the park brake applied,turn the vehicle ignition switch to the ON position. Do not start
the vehicle.
3.Shift the vehicle to reverse to power the transmitter.The blue power LED will light
continuously and the monitor will display the image from the camera.
4.If the image does not display, check your connections and make sure the camera view is not
obstructed.
7.Monitor Controls
Blue Power LED
The LED will blink when the monitor has power and is turned on, but the vehicle is not in reverse
(standby mode). When the vehicle is in reverse, and the monitor has power and is turned on, the
LED will light continuously.
Adjusting Monitor Settings
To adjust the following monitor settings, make sure the park brake is applied, turn the ignition
switch to the ON position and shift the vehicle to reverse.
