Taking a picture
1
Load film into the camera.
2
Place your subject approximately 40 inches (1 meter) in front of the camera.
3
Press the Aiming Button and aim the lights at your subject. The lights blink while
you aim the camera. Adjust the camera so that the lights converge on the sub-
ject's chin. See the opposite page for aiming tips.
4
If your subject has a dark complexion, press the Face Brightener (Boost) button.
The Boost light will come on in the LED display. The Face Brightener function
turns off after you take the picture. To turn the face Brightener off
before
you take the picture, press the Boost button again.
5
To take a picture, press the Shutter button. After you press the button, the
Pull Film light comes on in the LED display
,
or if the camera is
set to take another
picture on this film, it shows
Ready.
If it says
Ready,
take another picture.
Note: If nothing happens when you press the Shutter Button, the Aiming Lights
probably went out. When this happens, press the Aiming button and take the
picture again – before the Aiming Lights go out.
6
To begin processing the film, pull the white film tab. Then pull the yellow tab.
7
Develop the film. Refer to the film instructions for the recommended develop-
ment time.
8
You can lighten or darken your picture by adjusting the aperture lever and/or the
flash exposure setting (in the LED display). To lighten the picture, move the
aperture switch to the left; or increase the flash exposure from the LED display.
To darken the picture, move the aperture switch to the right; or decrease the
flash exposure.
