C. Adjusting the Float Hose
1. With the pool filtration pump off, connect the
float hose to the pool wall by turning the quick
disconnect clockwise into the universal wall
fitting. Pull away from the pool wall to secure.
2. Extend the float hose to the farthest point in
the pool.
3. Cut the float hose so it is four feet short of
the farthest point of the pool.
If the float hose does not come within four feet
of the farthest point, you will need to add a float
hose extension kit (part #6-221-00) available at
a participating Polaris dealer.
4. Remove the hose connector from the portion
of excess hose that was just removed and
attach it to the new end of the float hose. See
the diagram at the top of the next column.
5. Attach the sweep hose and the filter bag to
the jet sweep assembly. When attaching
the filter bag, make sure its frame is
completely open.
6. Attach the float hose and the sweep hose to
the surface module. When attaching the
Quick
Disconnect
Quick
Disconnect
Universal Wall
Fitting (Installed)
4
sweep hose, make sure the large ends of the
wheel cages are pointing toward the filter bag.
NOTE:
The connectors twist independently of the
hose. When attaching them, twist only the con-
nectors so the hose does not get twisted.
7.
Put the Polaris in the pool and turn on the pool
pump. Extend the float hose back to the far-
thest point in the pool. The float hose is cut
correctly if the surface module is
Surface
Module
Wheel
Cage
Jet Sweep
Assembly
Filter
Bag
Hanger Kit
(Optional Accessory
Part #6-109-00)
Float
Hose
Sweep
Hose
Approx.
Four Feet
Approx.
1' From the
Farthest
Point
Surface
Module
Float
Hose
Return Line
Collapse Here
Insert
to Here
Female
Hose
Connector
Removing the Connector
1. Collapse hose with fingers.
2. Replace connector with only first
corrugation inside lip of connector.
3. Pop hose back into shape.
