56
OPERATION
Starting the Engine
Starting a Cold Engine (Manual Start)
Do not depress the throttle until the engine starts.
1. Turn key to
ON
.
2. Pull kill switch (shut-off switch) up to
RUN
.
3. Flip choke toggle to
FULL ON
.
4. Grasp starter handle and pull slowly until recoil engages; then pull
abruptly to start the engine.
5. After the engine starts, flip the choke toggle to the
OFF
position.
If the engine slows or wants to stop, use intermittent choking to the
HALF ON
position.
Inadequate cooling and lubrication will lead to overheating of the
slide rail and track, resulting in premature wear and failure.
Reduce speeds and frequently drive into fresh snow to allow
adequate cooling and polishing of the slide rail and track
surfaces. Avoid operating on ice, hard-packed surfaces or roads.
CAUTION
Before starting the engine, always refer to all safety warnings
pertaining to snowmobile operation. Never start your snowmobile
without checking all components to be sure of proper operation.
See
Check Before Starting the Engine
beginning on page 51.
WARNING
Don’t pull the starter rope to full extended position or allow it to snap
back into the housing. Damage may result.
To avoid personal injury and/or engine damage, do not operate
the electric starter or pull-rope starter while the engine is running.
CAUTION
