Instr 9927475
Rev 01 2017-02
Page 7 of 14
2. Connect white electrical connectors as seen in the
top photo of the Electrical Connections Reference
Guide. Route power wires to battery area and
connect red or orange wire on control box to
orange wire on vehicle main wire harness as seen
below. Route black wires from control box
w
to
black (ground) terminal area on bus bar.
3. Now connect the red
G
and black
H
wires to the
bus bar terminals along with winch power cables
f d
using existing fasteners
P
. Also, connect
black wires on the wireless remote receiver box
e
and control box
w
to battery negative (ground)
terminal at this time.
4. Secure all remaining wires to vehicle main wire
harness using cable ties as shown.
HANDLEBAR SWITCH INSTALLATION
1. Install the handlebar switch
q
using the supplied
screws
P
onto handlebar as shown. Torque
screws to the specification listed below being
careful not to overtighten.
TORQUE
2 ft. lbs. (2.7 Nm)
2. Connect handlebar switch connector
S
to the
vehicle main wire harness as shown.
