Polaris RZR Trail S 1000 Premium 2022, Owner'S Manual

Page: 75 / 210

OPERATION
IMPORTANT INFORMATION
WARNING
Failure to operate the vehicle properly can result in a collision, loss of control,
accident or rollover, which may result in serious injury or death. Read and
understand all safety warnings outlined in the safety section of this owner’s
manual.
VEHICLE BREAK-IN PERIOD
The break-in period for your new POLARIS vehicle is the first 25 hours of
operation, or the time it takes to use the first two tanks full of gasoline. Clutch
and drive belt break-in periods vary depending on operating conditions.
No single action on your part is as important as a proper break-in period. Careful
treatment of a new engine and drive components will result in more efficient
performance and longer life for these components. Perform the following
procedures carefully.
NOTICE
Excessive heat build-up during the first three hours of operation will damage
close-fitted engine parts and drive components. Do not operate at full throttle
or high speeds during the first three hours of use.
Use of any improper oils may cause serious engine damage. POLARIS
Premium 4 Synthetic Oil is specifically formulated for your 4-cycle engine
ENGINE AND DRIVETRAIN BREAK-IN
1. Fill the fuel tank with the recommended fuel. See page 29. Always exercise
extreme caution whenever handling gasoline.
2. Check the oil level. See the Oil Check section for details. Add the
recommended oil as needed to maintain the oil level in the safe operating
range.
3. Complete the New Operator Driving Procedures outlined on page 79.
4. Avoid aggressive use of the brakes.
5. Vary throttle positions. Do not operate at sustained idle.
6. Perform regular checks on fluid levels, controls and areas outlined on the
daily pre-ride inspection checklist. See the Pre-Ride Inspection section for
details.
7. Carry only light loads.
73
OPERATION