Polaris PVCR 0926W, Operation Manual, Page: 22 / 117

Functions B are available when the device is in cleaning mode.
А. Increased time on both the clock and the timer.
B. The choice of the straight movement direction of the device.
А. Reducing the time on both the clock and the timer.
А. Switching from the minutes register to the hours register
B. The choice of the left movement direction of the device
А. Switching from the hour register to the minutes register
B. The choice of the right movement direction of the device.
12. To turn off the device, press and hold the Auto "button on the device for more than 3 seconds.
Note The set time on the clock or on the timer should be accompanied by a sound signal of the device. If there
is no sound signal your settings are not saved.
When replacing the batteries, the settings are busted. Remember to reset the time after replacing the
batteries. Display symbols
Device status Indicator color
Charging/Low Battery Flickering orange
Charged/In cleaning mode Green, constantly lit
Gives an error message Flickering red
BATTERY CHARGING 1. USING THE CHARGING BASE
When using the charging base the need to charge the battery is determined automatically by the device.
The I/O switch on the vacuum cleaner housing must be in the I position.
Place the charging base against the wall of the room to be cleaned next to the outlet, and then insert the
adapter plug into the outlet. The base signal indicator will light up.
Remove the obstacles 1 meter from both sides and 2 meters from the front of the charging base. (Fig. 5)
Aways use the battery base under normal operating conditions.
Do not leave the adapter plugged in after the battery is charged completely. Do not leave the charging base on
the floor when not in use.
Attention! It is strictly forbidden to short-circuit the contacts of the charging base with metal objects!
Fully charge the battery before long-term storage.
2. CHARGING THE BATTERY WITHOUT USING A CHARGING BASE
1. Before charging the battery, the vacuum cleaner must be turned off. Disconnect the device with
the I/O switch on the device housing moving it to the O position.
2. Insert the adapter plug into the charging socket on the vacuum cleaner housing.
3. Plug in the adapter. The indicator of the Auto button will flash orange.
4. Charging is complete when the Auto button indicator turns green. Unplug the adapter from the grid and
from the vacuum cleaner. Do not disconnect the charger until the battery is fully charged.
Note:
22