HANDLEBAR COMPONENT FASTENER
TORQUES
COMPONENT
TORQUE
DO NOT OVER-TIGHTEN
IMPORTANT: Moving a handlebar component without first loosening its screws/
set screws may cut grooves into the handlebar, making it difficult to secure the
component. Do not move a handlebar component without first loosening its
mounting screws/set screws.
Take care to avoid damaging hand warmer/brake switch wires when moving
components.
Left Hand Control/Brake Master Cylinder
24 in-lbs (2.7 Nm)
Upper / Lower Handlebar Clamps
7 ft-lbs (9.5 Nm)
Throttle Lever Block Set Screw
35 in-lbs (4 Nm)
Throttle Lever Block Cover Screws
6 in-lbs (0.7 Nm)
Auxiliary Engine Stop Switch Set Screw
12 in-lbs (1.4 Nm)
Hand Guard Mounts (if applicable)
Hand-Tight
45
Downloaded from
Summary of Contents for 550 Indy 2022
