Instr 9929139
Rev 01 2018-08
Page 5 of 13
6.
INSTALL WINCH HOOK.
a. Shift winch into “neutral” and pull rope/cable
o
6-12" (15-30 cm) out through fairlead. Install
hook
y
to the rope/cable by inserting clevis pin
through hook and rope/cable and securing with
a cotter pin.
7.
INSTALL DASH SWITCH.
a. Remove dash switch panel
A
by gently pulling
out along the edges. Once dash panel is out,
remove switch plug
B
.
b. Install dash switch
w
into the mounting hole by
pressing the switch firmly into position until it is
fully seated as shown.
8.
CONNECT ALL ELECTRICAL COMPONENTS.
NOTE
Refer to the Electrical Connection Reference Guide
section at the back of the instruction manual for
images and detailed harness connection illustrations
to aid in the remaining electrical connections.
IMPORTANT
When making connections, ensure all wires are
routed and secured with cable ties away from all
heat sources, moving components and sharp edges.
Failure to do so may cause damage to electrical
wires and/or underlying components which may
cause the winch to malfunction.
a. Locate the dash switch connector (12F) and
connect it to the dash switch
w
as shown.
Once connected, reinstall dash switch panel by
aligning all mounting tabs with corresponding
slots and firmly press back into the original
position.
b. Locate the winch contactor connector (12D)
and connect it to the control box connector
(12E) located towards the rear right hand side
of the winch.
