Instr 9927916
Rev 02 2018-07
Page 10 of 11
b. Insert threaded post and alignment pin located
on antenna base
a
through drilled holes in
fender, attach one end of ground strap
o
and
connector 11B on antenna harness
s
, then
secure with STEEL nut
d
. Install rubber boot.
IMPORTANT
Do NOT remove NYLON nut pre-installed to
threaded post.
NOTE
Fender shown partially transparent for clarity.
c. Remove nut
M
from ground stud, install loose
end of ground strap
o
, then reinstall nut.
NOTE
Ground strap improves AM reception.
d. Route connector 11A on antenna harness
s
rearward through firewall grommet
H
into
upper dash compartment.
NOTE
Antenna will be connected to head unit in Step 9.
Coil and stow excess antenna harness length in
upper dash compartment.
e. Thread antenna mast
i
into antenna base
a
.
7. OPTIONAL: Install auxiliary input.
a. Gain access.
i.
Remove two push pin rivets
N
from lower
face of control panel. Retain rivets.
ii. Rotate bottom of control panel rearward,
disengaging two side tabs
P
, then drop two
upper tabs
Q
out of slots in main dash
panel.
iii. Label and disconnect electrical harnesses
from switches, sockets, or other devices in
control panel.
