The 15° angle shown will prevent the outer
nozzles from overlapping with the center nozzle.
nozzle must be at a 15° angle
For proper/optimal spray coverage, the
End Nozzle Information
15°
(#5275122)
has a ratcheting motion.
This nozzle mounting stem
** Each "click" of the ratcheting motion is approx. 15° **
Valve "Open"
Valve "Closed"
Serivce Position
On/Off Valve Knob
out to check diaphragm condition.
Eliminate line pressure, then pull
Note: The check valve & diaphragm can fall out during transport,
if the knob is not turned to the "ON" or "OFF" position.
"On/Off" Valve Positions
End Nozzle Assembly Procedure
for Boomless "Wet" Boom
Start by sliding Item 17, 16, & 15 onto your boom tube as shown,
leaving about 1/2" to 3/4" between the end of the boom tube and Item 15.
2. Slide the (complete) end nozzle assembly onto the stainless steel
boom tube, with a somewhat "twisting" motion, so that the end face of the
3. Now push the "compression olive" (Item 16) against o-ring (Item 15) and
(Face1) surface to butt the end
of the boom tube up against.
slide (both) into the nozzle body opening firmly.
4. Firmly tighten flynut (Item 17) onto threads of nozzle body.
5. Repeat for other side.
Make sure the "Long" portion of Item 16 is facing the nozzle end.
boom tube "butts" up against "Face1" as noted.
(Sectioned Body)
1.
Assembled
End Nozzle
Your boom will come with the (2) end nozzle
assemblies NOT affixed to your boom tube.
Follow the instructions below to attach these
properly to the boom tube, as shown.
16
"Long" portion
15
17
Boom Tube (#5100316)
Page 3
