-3-
P/N 9924942 Rev 01 02/14
INSTALLATION INSTRUCTIONS:
PUSH FRAME EXTENSION:
WINCH LINK ASSEMBLY:
1. Position push frame (PN 2879630)
under the extension. Figure 1. Insert
two frame sleeves inside the rear
mounting holes of the frame. Fasten
the extension using two M10-1.5 x 50
mm hex. Bolts and two M10-1.5 hex.
Nylon nuts.
2. Position and fasten the two extension
clamps using two M10-1.5 x 120
mm hex. Bolts and two M10-1.5 hex.
Nylon nuts.
Figure 1
Figure 2
3. The original winch link must be
replaced by the new longer winch link
and M8-1.25 hex. Nylon nut supplied
with the extension kit.
a. Install winch link with nylon nut
until only two threads are showing
after the nut. Figure 2.
b. Lift the frame using the winch until
the winch stops itself (if you use
a winch with an automatic stop
switch) or until the winch hook
comes into contact with the roller
fairlead.
c. Try to lift the blade by hand. If the
blade can be lifted, the nut must
be tightened. Tighten until the
blade is at the maximum height
(maximum height is reached when
the stoppers on the extension
frame are in contact with the plates
of the quick-attach mechanism).
Hex Bolts
Hex Bolt
Hex
Bolt
Extension Clamp
Extension Clamp
Nylon Nuts
Nylon Nut
Nylon Nuts
Frame Sleeve
Frame Sleeve
Winch Link
Stopper for max
Lifting Height
IMPORTANT:
Polaris winch must be installed first. It is strongly suggested that your ATV front
suspension setup be changed to the stiffest setting.
