Polaris 2009 Ranger RZR, Owner'S Manual

Page: 89 / 146

85
MAINTENANCE
Fuses
If the engine stops or will not start, if the power steering stops working
(if equipped), or if you experience other electrical failures, a fuse may
need replacement. Locate and correct any short circuits that may have
caused the blown fuse, then replace the fuse.
The fuse box is located above the
power steering unit. One spare 20 amp
fuse is provided in the fuse box.
1. Remove the fuse box cover.
2. Remove the suspect fuse from the
fuse panel. If the fuse is blown,
install a new fuse with the same
amperage rating.
3. Reinstall the fuse box cover.
Tip: The 120 ohm resistor (if equipped) is
used by your Polaris dealer for power
steering diagnostics.
Spark Plugs
Spark Plug Gap/Torque
NOTICE: Using non-recommended spark plugs can result in serious engine
damage. Always use Polaris-recommended spark plugs. Refer to the
specifications section beginning on page 120.
Spark plug condition is indicative of engine operation. The spark plug
firing end condition should be read after the engine is warmed up and
the vehicle is driven at higher speeds. Immediately check the spark plug
for correct color. See page 86.
CAUTION! A hot exhaust system and engine can cause burns. Wear
protective gloves when removing a spark plug for inspection.
Fuse Feature Supported
15A Accessories, 12V Power Receptacle
15A Electronic Fuel Injection
15A Engine Control Module
15A Lights
20A Main Fuse - Ignition, Instrument Cluster
30A Power Steering (if equipped)
Electrode Gap New Plug Torque Used Plug Torque
.035" (.9 mm) 18 ft. lbs.
(24 Nm)
18 ft. lbs.
(24 Nm)