Polar Refrigeration G620, Instruction Manual

Page: 9 / 56

2
UK Telephone Helpline: 0845 146 2887 (United Kingdom)
Installation
1.
Remove the appliance from the packaging and remove the protective film from all surfaces.
2.
When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
3.
If necessary, adjust the screw legs of the appliance to make it level. The efficiency of the appliance
can be reduced if it is unevenly located.
Operation
Control Panel
Making Ice
Each time the appliance is refilled, the first ice making cycle is used to reduce the water temperature. This
results in uneven ice cube production which is perfectly normal. You may wish to discard ice created in the
first production cycle.
1.
Lift the access lid and fill the water tank up the level of the ice basket shelf.
2.
Connect the appliance to the power and press the START button.
3.
Press the SELECT button repeatedly to scroll through the ice cube sizes. Stop when the required size is
illuminated.
4.
The appliance will run a startup routine and then begin ice production.
5.
When the cubes reach the ice sensor the appliance will stop production. Production resumes once ice
has been removed.
6.
Press the STOP button at any time to halt the ice making process.
Note: If the appliance has been moved or transported in a non-vertical position, stand
it in an upright position for approximately 12 hours before operation.
Note: Before using for the first time, clean the water tank, ice basket and ice basket
shelf.
Note: Each ice making cycle takes between 6-12 minutes, depending on the size of cube
selected.
Note: If the water level is too low, the Water Low indicator lights up and the appliance
stops working. Fill the water tank and the appliance will restart automatically.
Ice cube size indicator