Polar Electro W518, Instruction Manual

Page: 9 / 76

2
UK
Telephone Helpline: 0845 146 2887 (United Kingdom)
Installation
1.
Remove the appliance from the packaging and the protective film from all surfaces.
2.
Avoid positioning the wine cooler in direct sunlight or damp areas.
3.
When positioning the wine cooler, maintain a distance of 20cm (7 inches) between the appliance and
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
4.
If necessary, adjust the screw legs of the wine cooler to make it level.
Reversing the Door
Depending on the location of the appliance, it may be necessary to change the direction the door of the
wine cooler opens by changing the side of the door handle.
To reverse the door handle:
1.
Remove the screw covers from the top of the
wine cooler with a small screwdriver.
Undo the two screws.
2.
Lift off the back of the wine cooler lid.
3.
Pull the lid forward to remove it.
4.
Unscrew the three securing bolts and the upper
hinge pin.
5.
Remove the upper door plate from the right
side position and place it on the left side of the
wine cooler. Attach the three securing bolts. Do
not insert the door securing pin at this stage.
6.
If necessary, carefully tip the wine cooler back slightly to
gain access to the lower door bolt.
7.
Unscrew the lower hinge pin and transfer the lower door
plate and pin assembly to the left side of the wine cooler.
8.
Lift the door from the lower hinge pin and put to one
side.
9.
Secure the lower door plate to the left side of the wine
cooler, attaching the securing bolts and the hinge pin.
10.
Remove the upper and lower screw covers from the
left- hand side of the door, and reinsert them in the right-
hand side of the wine cooler.
11.
Place the door on to the lower pin.
12.
Insert the upper hinge pin and tighten, ensuring the seals around the door are not squashed.
13.
Reattach the lid to the wine cooler. Ensure the front lip below the control panel is in place before
lowering the lid into position.
14.
Replace the two screws and the two screw covers at the back of the lid.
Note: If the appliance has been moved or stored in a non-vertical position, stand it in an
upright position for approximately 12 hours before operation. If in doubt allow to stand.
Securing bolts
Upper
door pin
Plate
Door