4
EN
Operation
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Turn the light switches On [I] or Off [O] as
desired.
Control Panel
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The display
will flash.
2. Press the
or
buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
The appliance will automatically run a defrost cycle
every 4 hours.
To manually defrost the appliance: Press and hold
the defrost button “ ” for 2 seconds to begin a
manual defrost. The defrost light illuminates.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
• If left unused for any length of time, store the
appliance with the door ajar.
Condensation and ice will form with frequent and
prolonged opening of the doors.
Operating outside of the recommend temperature
range and placing next to a heat source will also
increase the amount of ice and condensation.
Excessive ice will result in longer running times
that will increase energy consumption and increase
the deterioration of components.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
Probable Cause
Solution
The appliance is not
working
The unit is not switched on
Check unit is plugged in correctly and switched on
Plug or lead is damaged
Replace Plug or lead
Fuse in the plug has blown
Replace the fuse
Mains power supply fault
Check mains power supply
Appliance is noisy or
works intermittently
Appliance is not level
Check installation position and change if necessary
The appliance is touching a
neighbouring object
Check installation position and change if necessary
Cooler cabinet is not
cold enough
Temperature set incorrectly
Check temperature and reset if necessary
External environment may
require colder temperature
Check temperature and reset if necessary
The door is opened too often
Only open when necessary
Door seal is worn
Replace the seal
Condensation
Condensation may occur when the humidity is high and water particles in the air
contact with cold surfaces. This is normal, just wipe away with a dry cloth
GE580-GE581_GM813-GM814_ML_A5_v2_20221202.indb 4
GE580-GE581_GM813-GM814_ML_A5_v2_20221202.indb 4
2022/12/2 16:31
2022/12/2 16:31
