4
AU
Telephone Helpline: 1300225960
Operation
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Turn the light switches On [I] or Off [O] as
desired.
Control Panel
Set the Operating Temperature
1. Hold the
SET
button for 3 seconds. The display
will flash.
2. Press the
or
buttons to display the
required temperature.
3. Press the
SET
button to store the temperature.
Manual Defrost
• The appliance will automatically run a defrost
cycle every 4 hours.
• To manually defrost the appliance: Press and
hold the defrost button “ ” for 2 seconds
to begin a manual defrost. The defrost light
illuminates.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must
carry out repairs if required.
• If left unused for any length of time, store the
appliance with the door ajar.
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
Probable Cause
Solution
The appliance is not
working
The unit is not switched on
Check the unit is plugged in correctly and
switched on
Plug and lead are damaged
Call POLAR agent or qualified Technician
Power supply
Check power supply
Appliance is noisy or
works intermittently
Appliance is not level
Check installation position and change if
necessary
The appliance is touching a
neighbouring object
Check installation position and change if
necessary
Cooler cabinet is not
cold enough
Temperature set incorrectly
Check temperature and reset if necessary
External environment may
require colder temperature
Check temperature and reset if necessary
The door is opened too often
Only open when necessary
Door seal is worn
Call POLAR agent or qualified technician
Condensation
Condensation may occur when the humidity is high and water particles in the
air contact with cold surfaces. This is normal, just wipe away with a dry cloth
GE580-A_GE581-A_A5_v1_20210203.indb 4
GE580-A_GE581-A_A5_v1_20210203.indb 4
2021/2/3 16:01
2021/2/3 16:01
