3
3
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
NOTE: To prevent overloading a circuit, do not plug the fan into a
circuit that is servicing other electrical needs.
Turning Fan On:
Place fan on stable level surface. Plug fan
into properly grounded outlet. To start the fan, turn the switch
from the OFF position to the desired fan speed.
Turning Fan Off:
To turn the fan off, turn the switch from the
current fan speed setting to the off position. Remove plug from
outlet.
Adjusting Fan Tilt:
To adjust the tilt angle, use supplied
knob wrench to loosen the adjustment screw. After adjustment,
retighten the adjustment screw. Save knob wrench for future use.
Fan Cradle Assembly:
Simple assembly is required to use
this fan.
1. Align Cradle Base (packed separately) with support brackets
attached to fan body sides. Note: you may need to flex the
parts to make them align properly.
2. Insert support bracket into opening of Cradle Base. Press
spring loaded button down to allow it to insert into Cradle
Base, see Fig 1.
3. Press support bracket into Cradle Base until spring button
protrudes out open hole in Cradle Base, see Fig. 2.
4. Repeat above process for opposite side of fan.
Fig 1
Fig 2
Spring
Button
Cradle
Base
Support
Bracket
Spring
Button
