INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs •
REAR STINGER TIRE CARRIER INSTALL
Page 3
©2015 POISON SPYDER CUSTOMS • 951-849-5911 • WWW.POISONSPYDER.COM
10. Fold the Rear Stinger
upward, until the
upper bushings meet the mounting tabs in
the Upper Corner Mounts. You may need to
slightly adjust the Upper Corner Mounts to
allow the bushings to swing easily into the
tabs. Test for proper fitment with the supplied
hitch pins and cotter pins. Once everything
is satisfactorily aligned, tighten the hardware
for the Upper Corner Mounts. Remove the
hitch pins and fold the Rear Stinger back
down.
11. Roll your spare tire
onto the Rear Stinger
and lay it down with the outside of the wheel
facing down. Push the tire against the tire
stop on the Rear Stinger.
12. Place the 3-way Spare
Tire Strap over the
spare tire, with the two lower ends (with
metal mounting tabs) draped over each side
of the tire, and the upper end (with the ratchet
mechanism) draped over the end of the tire
that is farthest from the Jeep.
13. Use the supplied 7/16-14
X 1 Gr8 Hex
Head Cap Screws, flat washers and lock
nuts to secure each of the metal mounting
tabs of the 3-Way Spare Tire Strap to the
corresponding tabs on each side of the Rear
Stinger. Do not fully tighten this hardware
yet.
14. Pass the upper strap
of the 3-Way Spare
Tire Strap through the small loop at the upper
end of the Rear Stinger, then back through
the buckle.
15. Adjust the three straps
until, when tight, the
center ring is located near the center of the
tire. Once the strap is adjusted correctly, and
tightened, finish by tightening the hardware
that attaches the two lower straps to the tabs
on the Rear Stinger.
16. Test operation by folding
the Rear Stinger,
with tire mounted, upward and installing the
hitch pins into each Upper Corner Mount.
Insert the hairpin cotter pins into the holes in
each hitch pin to keep them in place while in
use.
Congratulations, you have completed the
installation of your Poison Spyder Rear Stinger
Tire Carrier!