point PTDW1, User Manual, Page: 21 / 180

Turning on the appliance
Starting a wash cycle...
Draw out the basket (see the section entitled "Loading the
Dishwasher").
Pour in the detergent (see the section “Fill the detergent”).
Insert the plug into the mains power socket. The power supply is
220-240VAC 50 HZ, the specification of the socket is 10 A 250 VAC.
Press the power button to turn on the dishwasher.
Connect the inlet hose to the tap, make sure that the water supply
is turned on to full pressure, or add water to the tank manually.
Select a suitable program according to the “Wash cycle table”.
If a program is selected, the response light will be on. Then press
the Start/ Pause button, the dishwasher begins to start.
NOTE:
When you press the Start/ Pause to pause during washing, the
dishwasher will mooing every minute unless you press the Start/Pause
button to start.
Change the program
A wash cycle can only be changed if it has been running for a short
time otherwise, the detergent may have already been released and
the dishwasher may have already drained the wash water. If this is the
case, the dishwasher needs to be reset and the detergent dispenser
must be refilled. To reset the dishwasher, follow the instructions
below:
1. Press Start/Pause button,than press any program button for more
will be in standby state.
2. Press the program button to select the desired program.
3. Press the Start/Pause button, the dishwasher will start.
NOTE:
If you want to open the door during washing, press the Start/Pause
button to pause the dishwasher first. When you close the door and
press the Start/Pause button, the dishwasher will then continue to
than 3 seconds, the dishwasher
21