FCC ID:
M5ZCNT
Installation and Operation Instructions for the Wireless Counter/Temperature.
Point Six, Inc.
Wireless Counter/Temperature Sensor
Model Point Sensor Counter/Temperature
Installation and Operation Instructions
The Point Sensor Counter/Temperature
sensor transmits a digital temperature, relative-
humidity (or light level) and a unique serial number to a 418 MHz receiver. The Point
Sensor Counter/Temperature
is enclosed in a high impact ABS enclosure for direct
surface mounting in the environment to be measured. The Point Sensor
Counter/Temperature
is battery operated.
Application:
Apply the sensor to the surface to be monitored with double-sided
adhesive tape. Make sure that the side labeled with FCC ID is visible and away from any
metal surfaces.
Service Function:
The wireless sensor has an installation mode switch. A momentary
push of this switch will start the convert/transmit cycles. When new and until this button
is pushed the Point Sensor Counter/Temperature
will not transmit. The Point Sensor
Counter/Temperature will transmit a special installation status mark in the data packet
immediately after the installation/start switch is pushed. After the start a push of the
installation switch will result in the immediate transmission of temperature, counter, ID
and installation status mark.
Battery:
A 3.6 Volt lithium battery powers the Point Sensor Counter/Temperature
wireless sensor. The battery will last for more than 10 years in the idle state (as shipped
from the manufacturer). The Point Sensor Counter/Temperature will transmit data for as
long as 5 years at a rate of once each minute once started. The Point Sensor
Counter/Temperature
is completely covered with a water resistant conformal coating to
protect the electronics from the environment and condensation. The user can replace the
battery. The Point Sensor Counter/Temperature
may be placed in a quiescent state
(battery life greater than 10 years) by holding the installation switch closed for more than
4 seconds.
