Environment and performance
SHELL
RAILS
CLEAT
TRIAX
WASHER
SCREW
NUT
GASKET
HARNESS
& STRAPS
Description
Part
Maintenenance
Recycling
ABS plastic, injection molded,
high impact modified and UV
protected, NEXA automotive
lacquer and UV protected
clear coat (not all versions are
coated).
POM plastic (Acetal), injection
molded.
PA6 plastic (Nylon), injection
molded.
M5 torx socket screw, zinc-iron.
M5 nut with nylon lock, steel.
Anti corrosive elctro plating.
EPDM rubber
600 D PE (outside), tripple PU
baking Neoprene 420,210 PE
(inside lining).
PVC gasket ledge (water seal)
EPS foam nylon straps, PA6 ITW
nylon buckles.
Bungee cord; nylon and rubber.
Zippers: steel.
Wipe clean with
damp cloth/soap
and water. Restore
lacquered shells with
car polish/wax. Rub
carefully.
Maintenance free
Maintenance free
Maintenance free
Maintenance free
Clean with soap and
water. Handwash
with mild detergent
without tensides.
Tensides may harm
the water protective
PU baking
Plastic
recycling
Metal
recycling
Rubber
recycling
Cut off nylon
buckles and
recycle, NR. 7.
Leave fabric
for combus-
tion disposal.
• EXTREME LOW TEMPERATURES WILL PROGRESSIVELY DECREASE
PROTECTIVE CHARACTERISTICS.
• REFRAIN FROM STORING OUTSIDE IN DIRECT SUNLIGHT FOR EXTENDED PERIODS.
• DO NOT CHECK IN. TEMPERATURE AND PRESSURE IN CARGO HAUL CAN AFFECT
PROTECTIVE CHARACTERISTICS. THE BOBLBEE 20L IS CABIN SIZE.
• This product contains no harmful substances related to use or recycling, if handled correctly.
• Plastics used and related Material Safety Data Sheets (MSDS) are in compliance with EU
directive 91/155/EEC, and are not considered dangerous or hazardous as waste.
• Fabrics are regularly controlled against content of cadmium and heavy metals. The materials
are not considered dangerous or hazardous as waste.
• Incinerating ABS / PE, PA synthetic fabrics: waste products are; CO2, CO and carbon hydrates.
Accidental breathing of smoke from burning material ; supply fresh air.
BOBLBEE 20L Product Data
!
The materials and construction of the BOBLBEE 20L have been
designed to withstand severe conditions. All fabrics have a tripple PU
coating (polyurethane) for water protection (market standard is double
coating). Plastics and lacquers have UV protection (ultra violet) against
extended exposure to sunlight. Screws and nuts are coated with anti
corrosive plating (to withstand 400 hours salt chamber-accelerated
weather testing. Stainless steel level is approximately 600 hours,
but much heavier). Mother earths conditions do put strain on most
products, and if you care about your protective equipment you should
not store it outside over extended time, like several months or years.
Extreme cold temperature affect most materials. It is less likely for
motorcycle riders, but for snow mobile riders and skiers travelling at
low temperatures (-15º to -30ºC) the protective characteristics can be
affected to some degree. At very low temperatures your body is also
acting slower and stiffer. Act in relation to your environment. Think
twice. Checking in your BOBLBEE 20L is not recommended, as you do
not have control of the loading. Extremely low temperatures and static
pressure of up 400 kg in cargo containers can cause damage.
