// 8
// 9
Connecting your subwoofer
We recommend that you read the instruction manual of your stereo amplifier or AV-receiver carefully before
connecting your MicroPod Sub.
Please also see Fig. 2 in this instruction manual.
First switch off the amplifier/receiver and all equipment before connecting your MicroPod Sub.
Connect the MicroPod Sub mains power cable to the socket (1) and to the mains voltage and push the
POWER ON/OFF
button (2) to
ON
position, the indicator lamp
POWER LED
(8) will now glow green and the
MicroPod Sub is active and ready to be used.
The MicroPod Sub has a built-in
AUTO STANDBY
(4) function.
To activate the
AUTO STANDY
function, set the switch (4)
AUTO
and after approximately 5-10 minutes
without any input signal from the amplifier/receiver, the MicroPod Sub will automatically switch off and the
indicator lamp
POWER LED
(8) will glow red.
When an input signal is detected, the MicroPod Sub will become active and the indicator lamp
POWER LED
(8) will glow green.
Should you wish to bypass the
AUTO STANDBY
function set the switch (4) to
ON
position and the
MicroPod Sub must now be turned on/off on the power switch (2)
Setting volume, frequency and phase
The volume, frequency and phase (controls 5, 6 & 7) can be adjusted on the rearpanel and we recommend
that you adjust the settings to your liking – try with different music and films. If you want more detailed
information on these control functions, we invite you to visit our homepage;
www.podspeakers.dk
Running-in period
We recommend a running-in time of your new MicroPod Sub of approximately 15-20 hours at normal
listening level before you decide on the final positioning and controls setting of the MicroPod Sub.
During the running-in time the 6½” subwoofer drive unit will settle in and perform as intended.
Care and cleaning
We do not recommend use of any solvents or cleaners on the lacquered cabinet.
The cabinet surface usually only requires dusting or cleaning with a soft cloth (do not use water).
• Do not use MicroPod Sub as a coffee or drinks table (risk of water being spilled into the enclosure).
• Do not remove the round front metal grille – this must be performed by qualified repair personnel.
• Disconnect the MicroPod Sub from the mains supply if taken out of use for a longer period.