5
©
PODAB 2018
Plinth for washer
1. Mount the forks at the
back side
with washers and screws.
Note!
Place the forks in their top position to use them to
guide the washer into the right position in the next step.
2. Check that the machine feet on the washer is fully inserted
and check that all counter nuts are tightened.
Prepare the plinth
1. Assemble the feet.
2. f the plinth is to be used with the tumble dryer, the exten-
sion should be fastened before continuing (for plinth with
art no 102059). Use the M8 screws and bolts.
(Step 3-4 can also be performed after the mounting of the
machine on top of the plinth if there is little room behind.)
3. Move the plinth to the desired installation place. Adjust the
plinth feet to level the top surface. Mark the position for
anchoring holes (see point 3). The punched arrow indicates
the front side of the plinth.
Assembly instructions
ENG
4. The plinth should always be anchored to the floor. PODAB
recommends the use of the supplied M8 expander bolts on
concrete floor. Secure one foot at the front and one at the
back, diagonally.