31
TX-LED- Transmit
Backlight
MENU+31
OFF/ BLUE/ ORANGE/ PURPLE
32
AL-MOD - Alarm Mode
MENU+32
SITE: Sounds alarm through your radio speaker only
TONE: Sending alarm tone
CODE: Sending alarm code
33
BAND - Band Selection
MENU+33
VHF:136-174MHz(RX)
UHF:400-520MHz(RX)
*In VFO/Frequency mode, sets [A] or [B] to the VHF or UHF
band.
34
TDR-AB - Transmit
selection while in Dual
Watch mode
MENU+34
OFF
A band transmit (Upper row frequency)
B band transmit (Bottom row frequency)
*When enabled, priority is returned to selected display once the
signal in the other display disappears.
35
STE - Squelch Tail
Elimination
MENU+35
ON
OFF
*This function is used eliminate squelch tail noise between
pofung handhelds that are communicating directly (no
repeater). Reception of a 55 Hz or 134.4 Hz tone burst mutes the
audio long enough to prevent hearing any squelch tail noise.
36
RP-STE-Squelch Tail
Elimination
MENU+36
OFF/ 1,2,3
…
10
*This function is used eliminate squelch tail noise when
communicating through a repeater.
37
RPT-RL - Delay the
squelch tail of repeater
MENU+37
OFF/ 1,2,3
…
10
*Delay the Tail Tone of Repeater (X100 milliseconds)
38
PONMSG-Power On
Message
MENU+38
FULL: Performs an LCD screen test at power-on
MSG : Displays a 2-line power on message
*Controls the behavior of the display when the transceiver is
turned on.
39
ROGER - Roger Beep
MENU+39
OFF
ON
*Sends an end-of-transmission tone to indicate to other stations
that the transmission has ended.
40
RESET – Restore defaults
MENU+40
VFO: Menu initialization
ALL: Menu and channel initialization
*Resets the radio to factory defaults, with some exceptions.
41
R-TONE–Repeater
Tone
MENU+41
1000Hz/1450Hz/1750Hz/2100Hz
*To send out a repeater tone; You hold down the [PTT] + [SOS]
key.
PO FUNG ELECTRONIC(HK) INTERNATIOANL GROUP COMPANY
Address: 3/F FULOK BLDG 131-133 WING LOK ST SHEUNG WAN, Hong Kong
Phone: +86-595-86752889
Fax: +86-595-86754889
E-Mail:
Http://www.pofungshop.com
Print version: P52UV_FCC_ V1
Disclaimer
The Company endeavors to achieve the accuracy and completeness of this manual, but no warranty of
accuracy or reliability is given. All the specifications and designs are subject to change without notice
due to continuous technological development. No part of this manual may be copied, modified,
translated, or distributed in any manner without the prior written consent of the Company.
We do not guarantee, for any particular purpose, the accuracy, validity, timeliness, legitimacy or
completeness of the third-party products and contents involved in this manual.
