connecting the antenna to the radio, it is necessary to check the correct operation of the
antenna with low standing wave ratio (S.W.R.) via adequate instruments. If not, the
transmitter circuit of the radio could be damaged. The antenna usually must be installed
on the highest part of the vehicle, free from obstacles and as far away as possible from
any source of electric or electromagnetic noise. The RF antenna coaxial cable must not
be damaged or pressed on its way between antenna and the radio. The correct operation
of the antenna and the low standing wave ratio (S.W.R.) must be checked periodically.
Connect the RF antenna coaxial cable to the antenna connector (15), located on the rear
side of the radio.
Checking Operation of the Radio
Once radio has been connected to the vehicle electric system and to the antenna, the
correct operation of the system should be checked. Please proceed as following:
1) Check that the power cable is correctly connected.
2) Check that the RF antenna coaxial cable is properly connected.
3) Connect the microphone to the connector (1) that is on the front side of the radio.
4) Rotate the SQUELCH (4) knob anticlockwise.
5) Turn radio on by the OFF/VOL (6) knob and adjust volume to the desired level.
6) Select the desired channel with the up/down key on the front side of the radio.
7) Rotate the SQUELCH (4) knob clockwise to cut the background noise.
8) Press the PTT key to transmit and release it to receive.
9) Check the level of the received and transmitted signals on the 4 bar RX signal Meter
and TX LED. The transceiver will work correctly.
5.
Useful tips
•
Do not invert power polarity
•
Do not replace the fuse with a bigger one. The default is 2A.
•
Do not transmit without an antenna connected, you risc damaging the
device.
•
Set the SQ and ASQ at the limit of the background noise.
6.
Legal frequencies and transmitting powers in Europe:
Italy 40CH AM/FM 4 watt
Italy 34CH AM/FM 4 watt
Germany 80 CH FM 4watt/ 12 CH AM 1watt
Germany 40 CH FM 4watt/ 12 CH AM 1watt
Summary of Contents for escort HP 8001 ASQ
