Technical helpline 0845 6037 212
Fx4
Two person lift minimum
!
Floor-wall stand assembly instructions:
3
Rear of ram-leg
Top of ram-leg
Ax8
1
Secure ram-legs to bottom wall bracket.
Note - Ensure ram-legs are orientated the same with the visible brackets at the rear.
2
Insert ram-leg inner and outer clamps.
2A - Insert inner clamp in to the corresponding brackets on rear of ram-legs
2B - Position outer clamp over the inner and secure with x4 fixings
Note - Do not fully tighten fixings at this stage.
3A
Bx8
3B
3C
3
Mount and secure the ‘Head’
3A - Thread both ram-leg cables through the corresponding holes in the base of the ‘Head’
3B - Lower ‘Head’ in to position
3C - Secure to ram-legs, tighten up fixings in a diagonal pattern
Secure the lift in place.
4A
- Position the lift in the chosen location and use it to mark the fixing points in the floor and wall.
4B
- Remove lift and prepare/drill all four wall positions and all six floor positions.
4C
- Re-position lift and secure in place
4D
- Tighten ram-leg inner and outer clamps together.
4
4C x4
4C x6
