Page 5 of 12
3.
IC Sockets
Now Install the sockets on the TOP of the board. Observe the notch or mark on the sockets and
align with the notch or mark on the board. Solder.
4.
Power socket
Install the 10 pin power socket on the TOP of the board.
This must be installed with the correct
orientation or the module will be damaged when the power is connected.
The cut-out in the socket should face the jacks,
aligning the cut-out with the "10" marking on
the board
as shown in the photo. Solder on the underside.
Summary of Contents for Clock Divider
Page 11: ...Page 11 of 12...
Page 12: ...Page 12 of 12...