Plymovent VSRX, User Manual

Page: 18 / 24

WARNING
The Balancer is delivered under tension. Be careful
when unwinding this balancer.
WARNING!
After the Safety Disconnect has released please
check if all spring blocks in the product are free of
damage and functioning correctly. Any damaged
parts should be replaced and the correct functioning
should be verified. If the Safety Disconnect is not
functioning correctly, it can potentially cause
damage to person or property.
Image: Tailpipe reducer
Image: Tailpipe support bracket
MAN_MAG_VSRX_290518_LETTER_EN
Page 18 of 24
5.3 Check the Balancer Tension
The balancer is delivered from the factory with pre-tension
already set. After every component of the system is installed,
you may need to adjust the balancer pre-tension to its final
setting, to ensure that the balancer is functioning properly.
Increase or decrease the spring tension until the rubber stop
loosely hits the balancer housing and cable is retracted.
It’s possible the balancer tension needs to be fine-tuned after
the total system is installed and a test run is done.
5.4 Safety Disconnect Handle
Function:
The safety coupling disconnect opens in case of missue of the
systemor failure of the disconnection and can allways be
re-used.
Adjustment:
The Safety Disconnect Coupling is delivered completely
assembled with a preset tension. The standard setting on
delivery gives you a release force at 450N and a reconnection
force of 150N.
Release Force:
You can adjust the safety coupling disconnect by using different
springs available from Plymovent. These are not included, so
please contact your Plymovent authorized distributor.
5.5 Tailpipe Modification Options
Tailpipe Reducer
The tailpipe adaptor is used when an exhaust tailpipe needs to
be converted from a smaller size to a larger size to allow the
conical tailpipe adapter to be installed.
New Art. # Old Art. # Description
00000113613 90365-1011
Tailpipe Reducer, 5 in. (127
mm) Male to 4 in. (101,6
mm) Female w/clamp
Tailpipe support bracket
The tailpipe support bracket can be used for various dimension
exhaust tailpipes and ensures a secure connection between the
tailpipe and body / chassis. In some cases, you may need to
divert the exhaust flow from the tailpipe to the side of the
vehicle. The Magnetic Grabber
®
connector can then be installed
to this modification.
When a tailpipe modification is needed, Plymovent recommends
you consult the manufacturer of the vehicle.
As an example, the image on the next page shows the
Plymovent tailpipe support bracket being used with a 3rd party
tailpipe reducer pack. This ensures a support a correct and
sturdy installation of the Magnetic Grabber
®
connector.
New Art. # Old Art. # Description
00000105131 90370-1011 Tailpipe Support Hanger